Build your first NAND circuit by opening Factory, placing one NAND gate, and connecting inputs a and b to its matching pins. Connect the gate’s out pin to y, then select Run Test. The four input rows 00, 01, 10, and 11 must return 1, 1, 1, and 0.
Read the first test
Start with both inputs low and follow the signal from the gate to y. Then set one input high at a time to check both single-high cases. The last row, with both inputs high, is the only row where NAND returns zero. If a row fails, use that same input combination while you inspect the wiring.
Make NOT from NAND
Route the same input to both NAND pins. When that input is low, the gate sees two zeroes and returns one. When it is high, the gate sees two ones and returns zero. Test both states before moving on to a circuit with separate inputs.
Follow the opening circuit sequence
The ten opening contracts cover NAND, NOT, AND, OR, NOR, XOR, XNOR, a multiplexer, a one-to-two decoder, and two-bit equality. Read the contract brief before wiring each design so you know what its output should represent. Use the truth table to find a failing combination before changing the circuit. Keep the failing input in view while tracing back from the output.
Test the multiplexer and equality circuit
Give the multiplexer two different data inputs, then toggle its select signal. That makes it easy to see whether the output follows the intended input. For two-bit equality, compare each pair of corresponding bits with XNOR. AND the two comparison results so equality is high only when both pairs match.
Continue beyond the Logic Trainer
The Steam demo contains the ten logic contracts and two later parallel-computing previews. The full game has 62 contracts across six eras. Its progression goes through arithmetic, memory, a programmable CPU, parallel execution, and matrix work. Use the official demos to get comfortable with the build-and-test cycle before tackling the later designs.