Search the wiki

Loading guides…↑ ↓ to navigate · Esc to close

IT THINKS Build Your Own GPU Sandbox Mode

In the full game, open Free bench from the hub, choose + New bench, set up the named inputs and outputs, and choose Create and open. Build the circuit and add its interactive controls, then switch to the front panel to operate the device. A button connected to a simple output is a good first check of that workflow.

Define the bench interface

Give the bench a name and configure its input and output pins. The published client offers an optional truth table on benches with six or fewer inputs. A truth table gives you a way to check expected results while you wire the circuit. The front panel gives you a separate way to operate the finished device.

Start with a simple panel

Place a button, connect it to a simple output, and switch to the front panel. Press the button and check that the output responds as intended. Once that works, try the other controls the full game lists, including a keypad, a buzzer, or dice. For visual outputs, Catchy lists seven-segment displays and a 16×16 lamp matrix.

Work within the bench capacity

Catchy lists a limit of 4,000 parts per bench in the full game. Start with a small circuit and verify its behavior from the panel before building a larger device. Keep pin names clear so you can identify which controls and outputs belong to the circuit. The available browser demo does not open Free bench.

Share an interactive device

The full game supports publishing a link to a Free bench device. Recipients can open the link and operate the device in their browser without signing in. Check the behavior of the front panel before sharing the link. For a challenge with a brief, rules, and a test, use the separate Community Puzzles workflow.

Sources